| Pack Size | 2 Pack |
| Material | Q235 Steel |
| Load Capacity | 5,000 lb per Jack |
| Adjustable Height | 21.06″–34.25″ |
| Adjustment Method | Power Drill or Hand Crank |
| Top Support | Flat Steel Plate |
| Intended Use | RV, Camper and Travel Trailer Slide Out Rooms |

Add steadying contact points beneath extended RV, camper and travel trailer slide out rooms while parked. This 2 pack uses q235 steel jacks with a 21.06″ to 34.25″ adjustable height range and a rated capacity of 5,000 lb per jack, helping reduce movement in occupied slide out spaces.

Pack Components
Position the 2 jacks beneath suitable slide out support areas to provide multiple contact points while your camper is parked

Drill Drive and Manual Crank
Use a compatible power drill to turn the jack drive, or operate it with the crank handle when manual adjustment is preferred

Telescoping Post and Threaded Rod
Set the telescoping section and fine tune the threaded top within the 21.06″ to 34.25″ adjustment range

Steel Upright and Circular Foot
Each support is rated for up to 5,000 lb; use these jacks to steady an extended slide out rather than lift the RV or trailer

A shaped steel top support provides a contact surface beneath the appropriate slide out area, while the height adjuster allows careful final alignment

After parking, place each base on firm, level footing and raise the support to make contact with the intended area; lower the jack again before leaving
| Pack Size | 2 Pack |
|---|---|
| Material | Q235 Steel |
| Load Capacity | 5,000 lb per Jack |
| Adjustable Height | 21.06″–34.25″ |
| Adjustment Method | Power Drill or Hand Crank |
| Top Support | Flat Steel Plate |
| Intended Use | RV, Camper and Travel Trailer Slide Out Rooms |
Choose the 2 pack for adjustable support at your camper slide out rooms. Steel construction, flexible height settings and two operating methods make the jacks practical to position during campsite setup.