I think the price, is a bit steep for the surface area. I donât like how thin the protective film is. They bend it to form, with it intact. âGreat idea protection wiseâ but, it makes it more difficult to take off. Iâd say the side pieces were ten minutes of peeling per. Iâve peeled this from other stainless items. Itâs nowhere near as difficult. They used a slightly thicker film though. Thatâs just something to look forward to when you get it. Itâs packed well. Mine did have an indentation in the steel. And, in the picture you can see, the finish job isnât great. The sides wonât be perfectly straight when assembled. So, you have to push them inwards or outwards before you put the screws in your wall. âKinda a standard thing with thinner metal shelvesâ The anchors it comes with, I tried using. But, the first one I installed, snapped in the drywall while I was turning it in place. âIt was over half way inâ so I had to dig out what I could. And, have a decent size hole now where that was. Luckily, the top splash guard area of the shelf is covering that hole. I slid the shelf over more, to get away from that hole. And, scrapped the screws and anchors. I ended up using deck screws to hold the shelf up. NOTE: I donât believe this was a fault in the anchors quality. They are perfectly suited for the job. âI have lath behind my drywall.â I didnât know it, until all this happened. I do like how they have slide notches in the side panels. This allows you to adjust each side, to perfectly match up with the upper shelf. Iâd say over all, itâs a great unit. Iâve got two different sizes of plates side by side, and two stacks of 3 bowls one stack in front of the other. All sitting on the shelf. You may not get a perfect looking shelf. But, it will be sturdy. I chose this one, over their other model with the hooks, because I thought the rounded front lip, was a cleaner look.